Setup Bass Face car audio system

Bass significantly increase overall quality of sound but we know most cars have not bass face audio system that’s why we setup manually but if cars have stock bass face audio systems that come by default from the assembly line. These systems can be good. Mainly two reasons if the current system has not proper hardware or bass face audio setup is not proper or complete. If this problem then it is better to choose right Bass Face car audio setup.

If you know how to setup Bass Face car audio then you do setup yourself. Through this way you can save your time and money. But at a setup time be careful and remember that not do any mistake. Before setup If possible then first note or remember each step how to setup Bass Face car audio?

setup Bass Face car audio by follow this step:

  • Disconnect the negative battery cable from the battery. Use a wrench or pliers to loosen the negative and positive battery cables.
  • Move the negative battery cable away from the battery terminal to prevent shorting the car’s electrical system and connected components.
  • Remove the positive battery cable and place the amplifier ring terminal onto the positive battery post. Return the positive battery cable to the positive battery post and tighten the cable to the battery with the wrench or pliers.
  • Connect the amp wiring kit power supply cable to the ring terminal. Remove the fuse from the car until the installation is complete.
  • Use an already established path to the inside the car or create a new one with a drill and 14 mm drill bit. Place a rubber grommet into the new opening in the firewall to protect the cable.
  • Remove the car stereo. Consult the car repair manual for exact instructions. Disconnect the stereo wiring and antenna cable from the back of the stock unit.
  • Pull the bass audio system and antenna cable from the back of the dock.
  • Plug the stereo wiring connectors into the leads of a wiring harness adapter. Plug patch cables into the leads of the adapter and feed them through the back of the stereo dock and down to the floor of the car.
  • Plug the wiring harness adapter leads, antenna cable and then connect the adapter to the antenna outlet.
  • Return to the car’s engine compartment. Place the negative battery cable back onto the negative battery post and tighten the cable to the terminal with a wrench.
  • Replace the fuse into the ring terminal fuse holder. Close the hood.